南平b1級不燃橡塑保溫管 耐寒防潮橡塑海綿管近期價格動態

橡塑保溫材料與其他保溫材料的泡孔結構比：

Rubber and plastic heat preservation material and other insulation foam pore structure than:

1、玻璃纖維：開孔結構水汽滲透率*（濕阻因子為3-5），導致隨使用時間延長導熱系數升高，使保溫效果大大降低。

1, glass fibre: open pore structure high water vapor permeability (wet resistance factor for 3 to 5), result in higher with the extension of use time coefficient of thermal conductivity, the heat preservation effect is reduced greatly.

2、發泡聚乙烯：連孔結構，添加阻燃劑后有較高的水汽滲透率（濕阻因子為1000），其材質硬而發脆，易破損，壽命短。

2, foaming polyethylene: even the pore structure, adding flame retardant has a high water vapor permeability (wet resistance factor of 1000), the material of hard and brittle, easy damage, short service life.

3、橡塑保溫材料：閉孔結構有極小的水汽滲透率（濕阻因子為10000以上）能長期保持較低的導熱系數。

3, rubber and plastic heat preservation material: obturator structure with minimal water vapor permeability (wet resistance factor of 10000 or above) to maintain low coefficient of thermal conductivity for a long time.

采暖、空調管道保溫材料性能比較表

Heating, air conditioning pipe heat preservation material performance comparison table

材料名稱 密度 導熱系數 溫度 經濟指標

The name of the material Density coefficient of thermal conductivity temperature indicators

水泥珍珠巖管 250-400 0.058-0.087 <600 不適用

Cement perlite tube 250-400-0.058-0.087 < 600 shall not apply

巖棉保溫管 100-200 0.082-0.058 -268-350 綜合成本高

Rock wool insulating tubes, 100-200-0.082-0.058-268-350 comprehensive cost is high

硅酸鋁纖維管 300-380 0.047-0.058 ≤1000 價格較高

Aluminum silicate fiber, 300-380-0.047-0.058 or less 1000 price is higher

聚苯乙烯塑料管20-50 0.031-0.047 -80-70 價格適中

Polystyrene plastic pipe 20 to 50 moderate price 0.031-0.047-80-80

聚氨酯預制保溫管 30-42 0.023 50-160 成本高

Prefabricated polyurethane insulation pipe 30-50-160 0.023 42 cost is high

橡塑絕熱保溫管 50-60 0.032 -50-110 價格相對低廉

Rubber insulation pipe 50 to 60 0.032-50-110 price is relatively cheap

水泥珍珠巖，巖棉，聚苯乙烯塑料

Cement perlite, rock wool, polystyrene plastics

南平b1級不燃橡塑保溫管 耐寒防潮橡塑海綿管近期價格動態

橡塑保溫管生產廠家在產品的運輸過程中總會遇到這樣那樣的問題，那能否對這些問題進行正確的分析，并提出解決方案就顯得尤為重要了。下面小編就來給您科普一下。

Rubber insulation pipe manufacturers in the process of the transportation of products will always meet this or that kind of problem, is that the correct analysis of these problems, and puts forward solution is particularly important. Below small make up just to give you the popular science.

    橡塑保溫管能夠減少取暖能源消耗，是新一代的節能保溫材料。上世紀70年代，不少國家已經開始重視建筑節能，橡塑保溫管開始走向市場，有效的減少了取暖保溫消耗的能源。

Rubber insulation pipe can reduce heating energy consumption, is the new generation of energy-saving insulation materials. In the 1970 s, many countries have begun to attach importance to building energy efficiency, rubber insulation pipe began to market, reduce the heating heat consumption of energy.

橡塑材料

Rubber and plastic materials

廊坊福佳斯新型保溫建材有限公司

Langfang at the new thermal insulation building materials co., LTD.

：

sales hotline:

二、產品特點:

Second, the product features:

2.1、 導熱系數低：平均溫度為0℃時，本材料導熱系數為0.034w/mk，而它的表面放熱系數高，因此在相同的外界條件下，使用本產品厚度比其它保溫材料薄一半以上能達到相同的保溫效果，從而節省了樓層吊頂以上的空間，節省投資。

, low coefficient of thermal conductivity: 2.1 when the average temperature of 0 ℃, this material coefficient of thermal conductivity is 0.034 w/mk, and its surface exothermic coefficient is high, so in the same external conditions, the use of more than half of the product thickness is thinner than any other thermal insulating materials can achieve the same effect of heat preservation, thereby saving the ceiling above the floor, save investment.

2.2、 阻燃性能好：本材料中含有大量阻燃減煙原料，燃燒時產生的煙濃度極低，而且遇火不熔化，不會滴下著火的火球，材料具有自熄來特征。按GB8624-1997《建筑材料燃燒性能分級方法》，本產品為B1級難燃材料，確保安全可靠。

2.2, the flame retardant performance is good: this material contains a large amount of flame retardant smoke reduction material, produced by the combustion smoke density is extremely low, and in case of fire don't melt, will not drop the burning fireball, self-extinguishing to characteristics of materials. According to GB8624-1997 "building materials combustion performance grading method", this product is a B1 level flame retardant materials, to ensure safe and reliable.

2.3、 安裝方便，外形美觀:因本產品富柔軟性，安裝簡易方便。管道安裝:可套上后一起安裝，也可將本管材縱向切開后再用膠水粘合而成。對閥門、三通、彎頭等復雜部件，可將板材裁剪后，按不同型狀包上粘合，確保整個系統的嚴密性，從而保證了整個系統的保溫性。又因本材料外表有橡膠的光滑平整，以及它本身的優異性能，不需另加隔汽層，防護層，減少了施工中的麻煩，也保證了外形美觀、平整。

2.3, easy installation, beautiful appearance, because this product is rich flexibility, easy to install and convenient. Pipe installation: can be put on after the installation together, also can use this glue of the reoccupy after pipe lengthwise. The valve, tee, elbow and other complex components, can clean the plate after cutting, according to the different type of bag glue, to ensure the rigor of the whole system, to ensure that the insulation of the whole system. And because of this material are rubber surface smooth level off, and the excellent properties of itself, does not need additional steam insulation layer, protective layer, reduce the trouble of construction, also ensure the beautiful appearance, smooth.

2.4、 抗振特性:橡塑絕熱材料具有很高的彈性，因而能zui大限度地減少冷凍水和熱水管道在使用過程中的振動和共振。

2.4, anti vibration characteristics: rubber insulation materials of high elasticity, and thus can minimize chilled water and hot water pipes in the process of using vibration and resonance.

2.5、 其他優點:橡塑絕熱材料使用起來十分安全，既不會刺激皮膚，亦不會危害健康。它們能防止霉菌生長，避免害蟲或老鼠嚙咬，而且耐酸抗堿，性能*。這些性能使橡塑成為保護管道的理想絕熱材料，防止它們因大氣介質或工業環境而受到腐蝕.

2.5, other advantages: rubber insulation is very safe to use and will not stimulate the skin, also not a health hazard. They can prevent mould to grow, avoid pests or mouse bite, and acid and alkali resistance, superior performance. These properties make rubber protection tube ideal insulation material, to prevent them from corrosion by atmospheric medium or industrial environment.